Some Shopbot guys helped me out with suggestions. speed.Įdit: This was for small difficult to sand pockets like in pics. vectric forum large bit speeds professional You can also mix glazes from a single manufacturer to produce shade variations or use different glazes in separate layers to obtain a special look. If you're getting good quality and chips, and bit is room temp or only warm at the end of the cut you're good.Įverybody has a different quality they want vs. Start conservative, and then increase feed/speed until quality you want degrades.then back it off say 10%. Notice cutout uses "Last Pass" but we used to do it like the pocket in VCP7's. 25 60vbit, and every wood/bit/machine is a different and this is just what has worked well for me after testing. Ignore RPM's and feed rate as this is for My machine and Centurion FEM Downcut and Kyocera. Note the "Edit Passes" and "Pocket Allowance" Tapered router bits can help you achieve high details in deep carving, improving the. Employment Opportunity / RFQ (Request for Quote).I HATE sanding pockets, so I've had good results doing them like this example(NOT tweaked just defaults for Hard Maple which is my base wood). Calculating Your Cut Settings: Basic Feeds and Speeds Information.Education - Forum for Technicians and Engineers.Mill holder broke! Don't buy the harbor freight POS.Recommendations - Micro Mill to CNC Conversion - What mill should I start with.Newbie- Broke tool T1 - Need offsets remeasure.It broke off the cutting part of the bit, while the Shank stayed inside the collet. I think there are a few reasons why the break happened:ġ - the plywood was "bending" up a bit because it was being pulled by the bit, and that distorted movements in XY.Ģ - some of the settings didn't match the bit capabilities in terms of overloadĪny ideas to determine the reason for the bit breaking off? My Pocket Toolpath was a "Raster, Climb, Last", with all other settings default. This is part of a 2-toolpath file, but it broke off after a few seconds making a small hole. Material: 3mm plywood with 6mm wasteboard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |